Common Work Holding Devices Used in a Shaping Machine

There are many ways in which work may be held while it is being machined on the shaping machine. The common methods are mentioned below:

(a) Chucks. Three jaws and four jaw chucks are mounted on shaper with suitable means to hold the work pieces.

Different types of Chucks

(b) Special Jig. Jig accurately locates the work in position for machining and holds it securely in position by means of clamping bolts, studs and screw.

Jig

(c) Angle Plate. The work is securely fastened to an angle plate with clamps or bolts.

Angle Plate

(d) Plain Vice. Plain vice is bolted to the machine table. It holds the work piece securely while machining.

Plain vice

(e) Universal Vice. This type of vice can be swivelled at any desired angle through a horizontal plane. It can be tilted and held stationary at an angle from the horizontal to the vertical by means of a hinged knee. Work is supported between the centres of dividing head.

Universal vice

(f) Clamps. Various clamps used on shaping machine are as follows:

(i) Screw heel clamp

(ii) Goose neck clamp

(iii) Universal adjustable clamp

(iv) Plain clamp

(v) U clamp

(vi) Single finger clamp

(vii) Double finger clamp

Clamps Used on Shaping Machine
Support Us By Sharing

Author: Aliva Tripathy

Taking out time from a housewife life and contributing to AxiBook is a passion for me. I love doing this and gets mind filled with huge satisfaction with thoughtful feedbacks from you all. Do love caring for others and love sharing knowledge more than this.

1 thought on “Common Work Holding Devices Used in a Shaping Machine

Leave a Reply

Your email address will not be published. Required fields are marked *

*

code